Permatex® High Strength Threadlcoker Red 10g
Click to zoom in

Permatex® High Strength Threadlcoker Red 10g

Permatex®
PX27010
  • High strength threadlocker for heavy-duty applications 10mm to 25mm
  • Especially well-suited for permanently locking studs and press fits
  • Adds 3,000 PSI holding power on slip and press fit assemblies
  • May require heat or special tools for removal
  • Gel formula provides "liquid reliability" without drips, globs, mess or waste
  • Great for overhead and vertical applications

  • High strength threadlocker for heavy-duty applications 10mm to 25mm
  • Especially well-suited for permanently locking studs and press fits
  • Adds 3,000 PSI holding power on slip and press fit assemblies
  • May require heat or special tools for removal
  • Gel formula provides "liquid reliability" without drips, globs, mess or waste
  • Great for overhead and vertical applications

OEM specified. Gel formula provides “liquid-reliability” without drips, globs, mess or waste. Available in three convenient sizes, the GEL TWIST™ pin-point applicator, the GEL SQUEEZE™ applicator, or the single-use pouch puts the Threadlocker right where you want it...on the part! High strength threadlocker for heavy-duty applications 10mm to 25mm. Especially well-suited for permanently locking studs and press fits. Adds 3,000 PSI holding power on slip and press fit assemblies. Replaces set screws and snap rings. Locks against vibration loosening. May require heat or special tools for removal. Conforms to ASTM D5363 AN0221 (Mil-S-46163A, Type I, Grade K).

Permatex High Strength Threadlocker Red Gel is well-suited for heavy-duty applications 10mm to 25mm and may require heat or special tools for removal.

Read More
Read Less

DIRECTIONS:

  1. Clean and dry parts using Permatex® Surface Prep™ activator.

  2. Remove protective cap.

  3. Turn dial to expose 1/8″ to 1/4″ of material beyond tip.

  4. Apply threadlocker to leading edge of male fitting,covering 5 to 6 threads. Avoid direct contact of tip to metal surface*.

  5. Assemble parts and tighten to recommended torque.

  6. Replace protective cap.*If contact occurs, expose 1/16” of material and wipe off with a clean towel.Temperature range: -65°F to 300°F (-54°C to 150°C).Refer to Technical Data Sheet for complete information.

NOTE: Permatex® Threadlocker Gel should not be used on plastic fittings. Do not use on food contact surfaces. Avoid food contamination during use and storage.

The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.

Your cart

×